If you’re looking to Sell EXFO FTB-8130NGE Gigabit Ethernet Test Module

FTB-8130NGE Power Blazer module
SDH Rate Options
155 = 155 Mbit/s (STM-1)
622 = 622 Mbit/s (STM-4)
2.5G = 2.5 Gbit/s (STM-16)
10G = 10G Gbit/s (STM-64)

SMARTMODE = Real-time signal discovery and alarm/error monitoring per channel

The FTB-8130NGE Power Blazer module offer a wide range of SDH test functions ranging from simple bit error rate (BER) testing to advanced characterization and troubleshooting procedures. These functions include:

• › Mixed and bulk payload generation and analysis from 64 kbit/s to 10 Gbit/s
• › High-order mappings: STS-1
• › Low-order mappings: VT1.5/2/6, TU-11/12/2/3
• › Unframed optical signal testing at 10 Gbit/s rate
• › Section/RS, Line/MS, high-order (HO) and low-order (LO) path overhead manipulation and monitoring
• › Section/RS, Line/MS, high-order and low-order path alarm/error generation and monitoring
• › High-order and low-order pointer generation and monitoring
• › K1/K2 OH byte capture
• › Tandem connection monitoring
• › Performance monitoring: G.821, G.826, G.828, G.829, M.2100, M.2101
• › Frequency analysis and power measurement
• › Payload block and replace
• › Frequency offset generation
• › DS1 loopcodes and NI/CSU loopback emulation
• › Automatic protection switching (APS) and service disruption time (SDT) measurements
• › Multichannel SDT measurements and real-time error/alarm monitoring for all STS-1/AU-4 channels
• › Round-trip delay measurements
• › DS1/DS3 auto detection of line-code framing and test pattern
• › Dual DS1/DS3 receiver testing
• › Independent transmitter and receiver testing
• › Through mode analysis
• › Intrusive Through mode
• › Programmable error/alarm injection
• › DS1 FDL
• › Fractional T1/E1 testing
• › DS3 FEAC

Buying, Selling, Trading EXFO FTB-8130NGE

If you’re selling your EXFO FTB-8130NGE please fill out form on the right hand side of page.